This application uses IrDA by default. If your smartphone doesn’t contain IrDA, you can use Wi-Fi Connectivity feature. This feature is compatible with a firmware version 0.2.18-r5 and higher for STB MAG 250.
In order to get System Settings on MAG 250, remove and plug-in power cable on MAG 250. Then click SETUP button on the original remote control of MAG250 many many times, until the System Settings will not appear.
You have to enable Remote control in System Settings of MAG 250. Set Name and Password for this feature.
IP Address of STB you can find in Network Info:
Firmware Version you can find in Device Info:
Ok, go ahead and configure MAG250 Remote.
MAG250 Remote supports autodiscovery, it means that the application finds compatible STBs itself, you just need to select you STB from the list and set Password.
P.S. If the firmware of your MAG 250 is lower than 0.2.18-r5, contact your IPTV service provider for advice to update the firmware.